10
FINAL INSTALLATION
1. Temporarily lift the motor housing (F) to the upper
mounting bracket (A) to determine which two motor
housing screws (N) preassembled in the sides of
the upper mounting bracket (A) align with the slotted
holes in the top edge of the motor housing (F).
Partially loosen the two motor housing screws (N) that
align with the slotted holes.
Remove the other two motor housing screws (N) from
the upper mounting bracket (A).
2. Slide the motor housing (F) over the motor (C),
aligning the slotted holes in the motor housing (F) with
the loosened motor housing screws (N) in the upper
mounting bracket (A). Twist the motor housing (F) to
lock, then re-insert the two previously removed motor
housing screws (N) and securely tighten all screws.
3. Partially insert the blade screws (AA) along with the
blade washers (BB) through the blade (H) and into the
blade arm (G). Tighten each blade screw (AA) with a
Phillips screwdriver (not included), starting with the
one in the middle. Repeat this step for the remaining
blades (H) and blade arms (G).
Hardware Used
AA
Blade Screw
x 12
Blade Washer
x 12
A
A
F
N
F
N
1
2
BB
3
AA
BB
H
G
