15
FINAL INSTALLATION
4. Partially loosen two motor plate screws (N) in motor
plate on underside of motor housing (D) and
remove the other motor plate screw (N). Align
slotted holes in fitter plate (H) with loosened motor
plate screws (N), allowing molex connections from
motor housing (D) to come through hole in fitter
plate (H). Twist fitter plate (H) to lock. Re-insert the
motor plate screw (N) that was removed and
securely tighten all three motor plate screws (N).
4
Motor
Plate
Molex
Connections
IH
D
5. Partially loosen two fitter plate screws (O) on the
underside of the fitter plate (H) and remove the
other fitter plate screw (O).
Locate molex conections from motor housing (D)
and remove plastic that holds these wires together.
H
5
Molex
Connections
O
D
IN
IN
6. Connect WHITE wire from LED light kit (F) to
WHITE wire from motor housing (D). Connect BLUE
wire from LED light kit (F) to BLUE (or BLACK) wire
from motor housing (D). Make sure molex
connections are secure.
F
6
WHITE
BLUE (or BLACK)
WHITE
BLUE
D
H
IN
O
