9
11.
11
Slip downrod (A) into yoke of motor housing (D),
align holes and re-install pin (L) and clip (M).
Tighten set screws and then tighten nuts. Slide
yoke cover (E) down until it rests on top of motor
housing (D).
A
M
L
E
D
Set Screw
and Nut
12.
13.
Depending on the length of downrod you use, you
may need to cut the lead wires back to simplify the
wiring. If you decide to cut back the lead wires, it is
suggested you do so in the following manner:
Take the lead wires and make sure you have pulled
them all the way through the top of the downrod.
Start at the TOP of the hanging ball on the downrod
and measure 8 in. of lead wire, and then cut the
excess wire off with wire cutters (not included).
IMPORTANT:
Do NOT cut safety cable (R).
NOTE:
If you do
not
cut back the lead wires,
Steps
12 and 13 are not necessary and you may
proceed to Step 14 instead
.
If you cut back the lead wires in Step 12, strip 1/2
in. of insulation from end of each wire -- WHITE,
BLACK and BLUE. Twist stripped ends of each
strand of wire within the insulation with pliers (not
included).
13
12
Hanging
Ball
8 in.
A
INITIAL INSTALLATION
