13
Attach blade arms (H) to the bottom of motor
housing (D) with motor screws (J) and motor
washers (R) previously removed (Step 5, page 7).
Tighten motor screws (J) securely.
Note
: Make sure to completely secure each blade
arm (H) before proceeding to the next.
If you do NOT wish to use the light kit
, skip to
Step 9.
If you DO wish to use the light kit
, proceed to
Step 4.
3.
To install the fan with the light kit, first remove the
three preassembled switch housing screws (S) from
switch housing preassembled on motor housing (D)
and also remove switch housing cap (U). Remove
switch housing cap screw (V) from center of switch
housing cap (U) with a Phillips screwdriver (not
included). Locate the BLUE and WHITE wires in the
switch housing labeled FOR LIGHT and remove
plastic from these two wires.
4.
FINAL INSTALLATION
Lowes.com/harborbreeze
5. Remove hex nut (O) and lock washer (P) from the
top of the threaded rod on light kit fitter (F) and
locate GREEN ground wire in switch housing. Gently
feed the wires from the light kit fitter (F) through the
center hole in the switch housing cap (U), and then
screw the switch housing cap (U) onto the top of the
threaded rod on the light kit fitter (F).
NOTE:
Once
the switch housing cap (U) is tight, make sure the
red dot inside the switch housing cap (U) lines up
with the red dot on the top of the light kit fitter (F).
Feed the wires from the light kit fitter (F) through the
ring on the end of the GREEN ground wire from the
switch housing. Route the previously removed lock
washer (P) and hex nut (O) over the wires,
tightening the hex nut (O) securely.
3
D
J
R
G
H
S
4
S
V
U
5
Switch
Housing
F
U
D
Green
Ground
Wire
O
P
D
Switch
Housing
