10
WIRING
IMPORTANT
: Using a full range dimmer switch to
control fan speed will cause a loud humming noise
from fan. To reduce the risk of fire or electrical
shock, do NOT use a full range dimmer switch to
control fan speed. (Fig. 3)
3
1
2
3
Dimmer
Switch
Speed
Switch
For illustrative purposes only
--
not
intended to cover all types of controls
3.
G
H
FINAL INSTALLATION
Temporarily raise motor housing (A) to mounting
bracket (B) to determine which two motor housing
mounting screws (N) align with slotted holes in motor
housing (A) and partially loosen these two motor
housing mounting screws (N). Remove the other two
motor housing mounting screws (N). Now, lift motor
housing (A) to mounting bracket (B) again, aligning
slotted holes in motor housing (A) with loosened
motor housing mounting screws (N) in mounting
bracket (B). Twist motor housing (A) to lock. Re-insert
motor housing mounting screws (N) that were
previously removed. Tighten all four motor housing
mounting screws (N) securely. (Fig. 1)
1
1.
2
2.
A
B
N
N
BB
AA
Partially insert three blade screws (AA), along with
three fiber blade washers (BB), to attach one blade
arm (G) to a blade (H). Then, tighten each blade
screw (AA), starting with the one in the middle (Fig. 2)
Repeat with remaining blades (H).
AA
Blade Screw x15
Hardware Used
BB
Fiber Blade Washer x15
