10
CLOSEMOUNT-STYLE FAN MOUNTING
Remove preassembled canopy cover from bottom
of canopy (F).
NOTE
: To remove canopy cover
from canopy (F), twist canopy cover until the two
small protrusions on the inner lip of the canopy
cover align with the two notches on the bottom of
the canopy (F). Pull on canopy cover to remove.
NOTE:
The downrod (C) and canopy cover are
not used in this type of installation.
1.
1
Canopy
Cover
F
Remove every other preassembled screw and
lock washer from top of motor housing (I).
Pull wires up through hole in the middle of the
canopy (F) and attach canopy (F) to motor
housing (I) using the three previously removed
screws and lock washers.
2.
3.
Tab
A
3
Temporarily hang fan on the tab on the mounting
bracket (A) using one of the
non-slotted
holes in
the canopy (F).
2
F
I
Screw
Lock Washer
F