9
DOWNROD-STYLE FAN MOUNTING
If you decided to cut back the lead wires in Step 4,
strip 1/2 in. of insulation from end of each wire --
WHITE, BLUE, PINK, GRAY AND RED (if
applicable). Twist stripped ends of each strand of
wire within the insulation with pliers (not included).
Depending on the length of downrod you use, you
may need to cut the lead wires back to simplify
the wiring. If you decide to cut back the lead
wires, it is suggested you do so in the following
manner:
Take the lead wires and make sure you have
pulled them all the way through the top of the
downrod. Start at the TOP of the hanging ball on
the downrod and measure 8 in. of lead wire, then
cut the excess wire off with wire cutters (not
included).
NOTE:
If you do
not
cut back the lead wires,
Step
5 is not necessary and you may proceed to
Step 6 instead
.
Hanging
Ball
4
8 in.
5
5.
4.
Install hanging ball of downrod (C) into opening of
mounting bracket (A). Align one of the slots in
hanging ball with tab in mounting bracket (A).
DANGER:
Failure to align one of the slots in
the ball with the tab may result in serious injury or
death.
Tab
A
6.
C
Slot
6
C
