9
DOWNROD STYLE FAN MOUNTING
If you decided to cut back the lead wires in Step 4,
strip 1/2 in. of insulation from end of white wire.
Twist stripped ends of each strand of wire within
the insulation with pliers (not included). (Fig. 5)
Repeat Step 5 for black, blue (if applicable) and
green wires.
5
5.
Install ball end of downrod (A) into mounting
bracket (C) opening. Align slot in ball with tab in
mounting bracket (C). (Fig. 6)
DANGER
: Failure to align slot in ball with tab
may result in serious injury or death.
6.
Continue to "Wiring" instructions on page 11.
6
Remove canopy cover from bottom of canopy (B).
(Fig. 1) [
Note
: It may be necessary to use the
handle end of a screwdriver (not included) to
remove the canopy cover by tapping on the
canopy cover from the
inside
of the canopy (B).]
*Helpful Hint
: Closemount style mounting is
more suitable for ceilings lower than 8 ft. (2.44 m)
high. The downrod (A), yoke cover (E), hanging
ball, and canopy cover are not used in this type of
installation.
CLOSEMOUNT STYLE FAN MOUNTING
1.
Canopy
Cover
B
1
Slot
Tab
C
A
B
