I
11
It is recommended you test the fan before finalizing
installation. Restore power from circuit box. Test
fan speeds with preassembled wall control. Start at
the
Off
position (no blade movement). One turn of
the dial will set the fan to HIGH (
H
). Two turns will
set the fan to MEDIUM (
M
). Three turns will set the
fan to LOW (
L
).
OPERATING INSTRUCTIONS
1.
2.
2
2
2
1
A
Test the oscillation function with the preassembled
pull chain (I). Pull the chain (I) to start
and
stop.
If fan does not function properly, please refer to
“Troubleshooting” section.
3. Use decorative nut (K) to adjust fan to the
desired position. The fan can be angled up or
down.
CAUTION
: To avoid personal injury or damage to
the fan, the fan MUST BE TURNED OFF before
adjusting.
K
2
3
