12
BLADE INSTALLATION (Continued)
LIGHT KIT FITTER ASSEMBLY INSTALLATION
2.
Position the blade (L) over the blade holder
arm (I) with threaded posts showing. Make
sure the bottom edge of the blade (L) is fully
seated against the blade holder arm (I).
Tighten washer-head screws (BB) with fiber
washers (CC) to secure the blade (L) to the
blade holder arm (I). (Fig. 2)
Hardware Used
BB
Washer-Head
Screws
CC
Fiber
Washers
x 10
x 10
2
CC
BB
I
L
NOTE: Periodically check blade holder hardware
and resecure if necessary.
WARNING
To reduce the risk of personal injury, do
not bend the blade holders when install-
ing, balancing the blades or cleaning the
fan. Do not insert foreign objects in
between the rotating blades.
3. Attach blade
holder arms (I)
to the
hub of motor
assembly (A) using screws (AA). (Fig. 3)
A
I
AA
Hardware Used
x 10
AA
Screws
3
H
1.
Remove one of the three screws in the support
bracket of the motor assembly (A). Slightly
loosen the remaining two screws. Assemble
the light kit fitter assembly (G) to the housing
support bracket of motor assembly (A) using
the two key slots in the light kit fitter assembly
(G).
Replace the third screw and secure all
three screws. (Fig. 1)
1
G
A