10
STANDARD OR ANGLE MOUNTING INSTRUCTIONS
4
. If installing the fan outdoors (optional),
feed the fan
wires through the holes in the downrod gasket (U).
Then, slide the downrod gasket (U) over the top of the
downrod (E).
Note:
If installing indoors, discard the downrod gasket
(U) and proceed to step 5.
Note:
The yoke gasket (T) will not be used in this type
of installation.
5. Install the ball end of the downrod (E) into the opening of
the mounting bracket (A). Rotate the fan in the mounting
bracket (A) until a slot in the ball of the downrod (E)
engages the tab in the mounting bracket (A).
DANGER:
The fan and/or downrod (E) should
not rotate in the mounting bracket (A) if installed
correctly. Failure to align the slot with the tab may
result in the fan falling, which could cause serious
injury or death.
Proceed to
Wiring
page 13.
5
4
E
E
A
A
E
U
Tab
Slot