11
CLOSEMOUNT INSTRUCTIONS
1. Remove and discard the canopy cover (C) from the
bottom of the canopy (B).
Note:
The downrod (E) and canopy cover (C) are not
used in this type of installation.
2.
If installing the fan outdoors (optional),
feed
the fan wires and antenna from yoke of the motor
assemby (L) through the holes in the yoke gasket (T)
and the canopy (B). Then, slide the yoke gasket (T)
over the yoke.
Note:
If installing indoors, discard the yoke gasket (T)
and proceed to step 3.
Note:
The downrod gasket (U) will not be used in this
type of installation.
3. Remove the three Phillips-head closemount screws
(AD) from the top of the motor assembly (L). Align
the canopy (B) with the holes in the top of motor
assembly (L), then re-install the Phillips-head
closemount screws (AD) to secure the canopy (B) to
the motor assembly (L).
B
C
T
L
B
L
AD
B
1
3
2
Antenna
Yoke