8
9
ASSEMBLY INSTRUCTIONS
7. Insert the receiver from the remote pack (L) into the
mounting bracket (A) with the flat side towards the
ceiling. Connect
BLACK
wire from receiver to
BLACK
wire from ceiling. Connect
WHITE
wire from receiver
to
WHITE
wire from ceiling. Connect all
GROUNDED
(GREEN)
wires together from fan to
GREEN/
GROUNDED
wire from ceiling. Connect the male plug
from fan to female plug from the receiver together.
NOTE: BLACK
wire is hot power for fan and light kit.
WHITE
wire is common for fan and light kit.
GREEN
wire is grounded wire. lf house wires are different
colors than referred to above, stop immediately and
consult a professional electrician to determine proper
wiring.
H
B
EE
7
Grounded/Green
Black
White
Grounded/
Green
Black
White
Blue
A
Hardware Used
8. Twist wire ends together and screw wire connectors
(AA) on in a clockwise direction. Tape wire
connectors (AA) and wires together with electrical
tape (not included).
8
ASSEMBLY INSTRUCTIONS
10. Slide canopy cover (C) over two screws and rotate
clockwise until it locks.
11. Attach blade (G) under blade arm (F) using three
decorative nuts (CC) and three blade screws (DD).
Repeat for remaining blades (G), blade arms (F),
decorative nuts (CC) and blade screws (DD).
Hardware Used
DD
F
G
CC
11
C
10
x 4
Wire Connector
AA
NOTE:
After making connections, make sure bare
wire or wire strands are NOT visible. Place green
and white connections on opposite side of box from
black and blue connections. Splices should be turned
upward and pushed carefully up into outlet box.
AA
NOTE:
Adjust screws as necessary until canopy (B)
and canopy cover (C) are snug.
CC
Decorative Nut x 15
DD
Blade Screw x 15 + 1 extra
9. Slide canopy (B) up against ceiling and over two
screws on mounting bracket (A). Rotate canopy (B)
clockwise to lock it into place. Tighten two screws.
Screws
B
A
9
6. Install hanger ball on top of downrod (E) into
mounting bracket (A) opening. Rotate fan until slot on
hanger ball engages the tab on mounting bracket (A).
Slot
A
E
Tab
6
ON
ON / OFF
switch
NO Variable
speed wall
control
NO Dimmer
switch
Important:
Do NOT use this fan with dimmer switch
or variable speed wall control. Using a dimmer switch
or variable speed wall control will damage the fan.
DANGER:
Be careful when aligning tab to slot.
If not fully engaged, the fan could fall, which could
result in serious injury or death.