K
J
INITIAL INSTALLATION
5
5. Remove motor screws (J) and 6 mm lock
washers (K) from underside of motor and save for
blade arm (H) attachment later on. [If there are
plastic motor blocks installed with the motor
screws (J) and 6 mm lock washers (K), discard
the plastic motor blocks.] (Fig. 5)
Follow mounting instructions on pages 7 and 8 for
“Downrod Style Fan Mounting” or proceed to
pages 8 and 9 for “Closemount Style Fan
Mounting”, depending on mounting method (A or
B) chosen in Step 2 on previous page.
Remove pin (M) and clip (N) from motor housing
yoke at top of motor housing (D) and partially loosen
set screws. (Fig. 1)
*
Helpful Hint:
Downrod style mounting is best
suited for ceilings 8 ft. (2.44 m) high or higher. For
taller ceilings you may want to use a longer downrod
(sold separately) than the one provided. Angle style
mounting is best suited for angled or vaulted
ceilings. A longer downrod is sometimes necessary
to ensure proper blade clearance.
Set
Screw
DOWNROD STYLE FAN MOUNTING
1.
D
M
N
1
Insert downrod (A) through canopy (B). Thread
wires from motor housing (D) through downrod
(A). (Fig. 2)
2.
2
A
B
A
Slip downrod (A) into motor housing yoke, align
holes and re-install pin (M) and clip (N).
Re-tighten set screws in motor housing yoke
and then tighten nuts. (Fig. 3)
3
3.
7
D
Set
Screw
D
M
N
