To reduce the risk of personal injury, do not bend the
blade when installing, balancing the blades or
cleaning the fan. Do not insert foreign objects in
between the rotating blades.
WARNING
!
11
How to Install Your Canopy Housing
2.
Securely attach and tighten the canopy screw cover
over the shoulder screws in the hanger bracket utilizing
the keyslot twist-lock feature. (Figure 2)
1.
Remove one of the two shoulder screws in the
hanger bracket. Loosen the second shoulder screw
without fully removing it. Assemble canopy by
rotating key slot in canopy over shoulder screw in
hanger bracket. Tighten shoulder screw. Fully
assemble and tighten second shoulder screw that
was previously removed. (Figure 1)
WARNING
To avoid possible fire or shock, make sure that the
electrical wires are completely inside the canopy
housing and not pinched between the housing and the
ceiling.
NOTE: This step is applicable after the neccessary wiring is completed.
Canopy Screw
Cover
How to Assemble
Your
Ceiling Fan Blades
NOTE:
Periodically check blade hardware and
resecure if necessary.
To reduce the risk of electric shock, disconnect the
electrical supply circult to the fan before installing
light kit.
CAUTION
Canopy
Figure 1
Blade
Motor Assembly
(3 per assembly)
Figure 1
Figure 2
1.
Slide blades through slots in the motor assembly and
position over the threaded posts of the motor assembly.
Make sure the bottom edge of the blades are fully
seated against the flywheel of motor assembly. Tighten
serrated-head screws with stainless flat washer to
secure the blades to the threaded posts of motor
assembly. (Figure 1)
x 15
x 15
STAINLESS
FLAT WASHER
HARDWARE USED:
ß
SERRATED HEAD
SCREWS
Ý6HDG
Screw with Stainless Flat Washer
