Downrod
Set Screw
Hanger Ball
7
How to Assemble Your Ceiling Fan
1
.
Remove the hanger ball
portion
from the downrod/
hanger ball assembly by loosening the set screw in the
hanger ball until the ball falls freely down the downrod.
Remove the pin from the downrod, then remove the
hanger ball. Retain the pin and hanger ball for reinstal-
lation in Step 8. (Figure 1)
Downrod
Set Screws
and nuts (2)
Figure 1
Figure 2
Motor
Assembly
4.
Thread downrod into the downrod support on top of
the motor. Install the clevis pin by aligning the holes
in the downrod support with holes in the downrod.
Secure clevis pin with hairpin clip. Tighten the two set
screws with nuts in the downrod support. (Figure 4)
WARNING
It is critical that the clevis pin in the downrod support
is properly installed and the set screws and nuts are
securely tightened. Failure to do so could result in
the fan falling.
2.
Remove the hairpin clip and clevis pin from the
bottom of the downrod. Retain the pin and clip for
reinstallation in Step 4. (Figure 2)
Hairpin
Clip
Clevis Pin
Downrod
Clevis Pin
Hairpin Clip
Figure 4
Figure 5
5.
Remove the two screws in the motor assembly
and retain for later. (Figure 5)
Figure 3
Black, White and
Blue Wires
Set Screws and
Locking Nuts (2)
3.
Loosen the two set screws and locking nuts in
the downrod support of the motor assembly. Route
the black, white and blue wires through the
downrod. (Figure 3)
