10
INITIAL INSTALLATION
10. Depending on the length of downrod you use, you
may need to cut the lead wires back to simplify the
wiring. If you decide to cut back the lead wires, pull
them all the way through the top of the downrod. Then
measure 8 inches of lead wire and cut the excess wire
off with wire cutters (not included).
11. If you decided to cut back the lead wire in Step 10,
strip 1/2 in. of insulation from the end of each wire.
Twist the stripped ends of each strand of wire within
the insulation with pliers (not included).
If you did not cut back the lead wires in Step 10, Step
11 is not necessary and you may proceed to Step 12
instead.
12. Install the ball end of the downrod (A) into the opening
of the mounting bracket (D). Align a slot in the ball
with the tab in the mounting bracket (D).
Important:
The downrod (A) should not rotate if
installed correctly.
DANGER:
Failure to align a slot in the ball with
the tab in the mounting bracket may cause the fan to
wobble or fall, which could result in serious injury or
death.
A
D
Tab
Slot
10
11
12
8 in.
