4.
To stop the ATV, release pressure on the Throttle Pedal (part #19) and the ATV
will automatically stop. (See Figure C.)
5.
NOTE: To avoid damage to the ATV, make sure to completely stop the ATV prior
to changing speeds (Low or High) and directions (Forward or Reverse).
6.
When finished riding the ATV, make sure to turn the Ignition Key (part #22)
clock-
wise to its “off” position and remove the Ignition Key. (See Figure C.)
INSPECTION, MAINTENANCE, AND CLEANING
1.
NOTE: ALL INSPECTIONS, MAINTENANCE, AND CLEANING SHOULD BE
PERFORMED ONLY BY AN ADULT.
2.
CAUTION: Always turn the Ignition Switch to its “OFF” position and remove
the Ignition Key before performing any inspection, adjustments, mainte-
nance, or cleaning.
3.
BEFORE EACH USE, inspect the general condition of the ATV. Check for loose
screws, misalignment or binding of moving parts, cracked or broken parts, dam-
aged electrical wiring, excessively loose wheels, and any other condition that
may affect its safe operation. If abnormal noise or vibration occurs, have the
problem corrected before further use.
Do not use this product if it is damaged.
4.
BATTERY AND FUSE REPLACEMENTS: For your personal safety, it is recom-
mended that only a qualified technician replace the 6 Volt DC Batteries (part #11)
and 40 Amp Fuses (part #24).
5.
DAILY: With a soft brush, cloth, or vacuum, remove all dirt and debris from the
ATV. If necessary, a mild detergent may be used. Do not expose the electrical
system of this product to water or any other liquids. When necessary, use a
premium quality, lightweight oil to lubricate all moving parts.
PLEASE READ THE FOLLOWING CAREFULLY
THE MANUFACTURER AND/OR DISTRIBUTOR HAS PROVIDED THE PARTS LIST AND ASSEMBLY
DIAGRAM IN THIS MANUAL AS A REFERENCE TOOL ONLY. NEITHER THE MANUFACTURER OR
DISTRIBUTOR MAKES ANY REPRESENTATION OR WARRANTY OF ANY KIND TO THE BUYER
THAT HE OR SHE IS QUALIFIED TO MAKE ANY REPAIRS TO THE PRODUCT, OR THAT HE OR SHE
IS QUALIFIED TO REPLACE ANY PARTS OF THE PRODUCT. IN FACT, THE MANUFACTUER AND/
OR DISTRIBUTOR EXPRESSLY STATES THAT ALL REPAIRS AND PARTS REPLACEMENTS SHOULD
BE UNDERTAKEN BY CERTIFIED AND LICENSED TECHNICIANS, AND NOT BY THE BUYER. THE
BUYER ASSUMES ALL RISK AND LIABILITY ARISING OUT OF HIS OR HER REPAIRS TO THE
ORIGINAL PRODUCT OR REPLACEMENT PARTS THERETO, OR ARISING OUT OF HIS OR HER
INSTALLATION OF REPLACEMENT PARTS THERETO.
SKU 03516
PAGE 11
