7.
DO NOT ATTEMPT TO REMOVE DEBRIS OR FOREIGN MATERIAL CAUGHT
IN THE MOVING PARTS OF THIS PRODUCT WHILE THE ATV’s IGNITION IS
IN THE “ON” POSITION. Turn the Ignition Switch to its “OFF” position and
remove the Ignition Key.
8.
GROUND THE ELECTRIC ADAPTER TRANSFORMER OF THIS PRODUCT.
The 12 Volt DC Adapter Transformer (part #14) for this product is equipped with a
2-Prong Plug and requires the use of a grounded, 3-Prong Adapter Plug (not
included). To comply with the National Electric Code, and to provide additional
protection from the risk of electrical shock, this product should only be connected
to a 120 Volt, 3-hole electrical outlet that is protected by a Ground Fault Circuit
Interrupter (GFCI). (See Figure A.)
12 VOLT DC
ADAPTER TRANSFORMER (#14)
3-PRONG ADAPTER PLUG
(NOT INCLUDED)
GROUNDED, 120 VOLT AC
ELECTRICAL OUTLET
FIGURE A
9.
REDUCE THE RISK OF ACCIDENTAL STARTING. Make sure the ATV’s Ignition
Switch is in the “OFF” position and the Ignition Key is removed before plugging
the 12 Volt DC Adapter Transformer into a grounded, 3-hole, 120 Volt, electrical
outlet.
10.
DO NOT ABUSE THE 12 VOLT DC ADAPTER TRANSFORMER CORD. Do
not use the Cord to pull its Plug from an electrical power outlet. Keep the Cord
away from heat, oil, sharp edges, and moving parts. Route the Cord safely. Do
not route the Cord where it can be walked on or tripped over. Replace a dam-
aged Cord immediately.
11.
IF AN ELECTRICAL EXTENSION CORD (not included) IS USED WHEN
CHARGING THIS PRODUCT, MAKE SURE TO USE ONLY UL APPROVED
CORDS HAVING THE CORRECT GAUGE AND LENGTH.
(See Figure B, next page.)
12.
PROPER BATTERY CARE: Battery leakage may occur under extreme usage or
temperature conditions. Never allow children to handle the two 6 Volt DC
Batteries for this product. If Battery fluid comes in contact with skin, wash with
SKU 03516
PAGE 4