5.
Continue inserting the Front Steering Linkage (part #2) upward through the
Sleeve (part #7). (See Figure D.)
6.
Insert a Washer (part #3) on each side of the Front Steering Linkage.
(See Figure D.)
7.
Hammer a Cap Nut (part #8) firmly onto each end of the Front Steering Linkage
(part #2). (See Figure D.)
8.
Connect the middle portion of the Front Steering Linkage (part #2) to the Steering
Rod (part #9), and secure the Front Steering Linkage to the Steering Rod with a
Cotter Pin (part #10). (See Figure D.)
CAP NUT (#8)
WASHER (#3)
SLEEVE (#7)
VIBRATION MUFFLER (#6)
FRONT BUMPER (#5)
FRONT CHASSIS (#4)
WASHER (#3)
FRONT STEERING LINKAGE (#2)
WHEEL (#1)
STEERING ROD (#9)
COTTER
PIN
(#10)
FIGURE D
To Install The Back Rest:
1.
Insert the Back Rest (part #20) into the two mounting holes located at the rear of
the ATV. Then secure the Back Rest to the ATV, using four Screws (part #21).
(See Figure E, next page.)
SKU 03516
PAGE 8