SKU 2448
Page 5
7.
Fit Suction Hose [1] over the Vacuum Body with Air Switch Assembly [10].
8.
To connect the Hose to an Abrasive Blast Cabinet (not included), unscrew the
Connecting Nut [2-2] and remove the O-Ring [2-1]. Fit the Connecting Hose [2]
into the 1-1/4” Dia. outlet in the Blast Cabinet. Reaffix the O-Ring and the
Connecting Nut to the Hose from the inside of the Blast Cabinet. Be sure the
Hose is tightly connected before use.
Air Connection
Note: Air Compressor is not supplied.
1.
You will need to prepare a 1/2” Air Connector (not included with this product)
and connect it to the valve located on the Vacuum Body with Air Switch
Assembly.
2.
Wrap the Air Connector with a pipe thread seal tape before connecting to a
3/8” I.D. Air Source Hose (not included). Connect the Air Source Hose to the
Valve.
3.
Air pressure should not exceed 125 psi.
This air powered product requires lubrication during operation. For best results, it
is recommended to have an oiler and water filter in line with the air supply as
shown. This will extend the life of the product.
Operation
The product is intended for use with a 10-60 gallon Abrasive Blast Cabinet (not
included). Read all instructions for Operating the Sand Blast Cabinet before using
this product.
1.
Follow instructions in Step 8, above, for connecting the Hose to the Sand
Blast Cabinet.
2.
Connect the Dust Collector to the Air Compressor according to the
instructions on Page 5, “Air Connection.”
3.
Use the Air Switch attached to the Air Switch Assembly to control the amount
of air flow through the product. Air Compressor pressure should not exceed
125 psi.
DUST
COLLECTOR
