SKU 02969
For technical questions, please call 1-800-444-3353.
Page 4
Warning: The warnings, cautions, and instructions discussed in this instruction
manual cannot cover all possible conditions and situations that may occur. It
must be understood by the operator that common sense and caution are fac-
tors which cannot be built into this product, but must be supplied by the opera-
tor.
Unpacking
When unpacking, check to make sure all parts listed on Page 6 are included.
If any parts are missing or broken, please call Harbor Freight Tools at the number
on the cover of this manual.
Assembly
All parts numbered and listed refer to those in the Assembly Diagram and Parts
List on Pages 5-6.
1.
Attach the Backrest Bar [7] to the Front
Frame [10] by depressing the two Brass
Buttons [8] on the sides of the Backrest
Bar, and sliding the Bar into the slots in
the Back Frame as shown in Fig. A, right.
2.
To attach the two Handles, first slide one
of the Handrail Rods [3] into the Front
Frame [10] as shown in the Assembly
Diagram. Find a comfortable height for
the Handle, then line up the holes in the
Handrail Rod with one of the holes in the
Front Frame. Secure in position using an M6
Screw [42], and Knob [5]. Repeat to attach
the other Handle, making sure that both
Handles are the same height.
3.
Your Walker/Stroller is easily collapsible,
when you want to take it in the car, on an
airplane, or for other storage purposes.
Simply remove the Basket [49] and the
Backrest Bar, and pull up on the Folding
Strap [51] as demonstrated at right in Fig.
B. To unfold the Walker/Stroller, place all
four of the Wheels [22] on the ground and
push down on the Handles until the Folding
Side Braces [38] are parallel to the ground
and the Walker/Stroller is locked in the open
position.
Fig. A, Attaching the Backrest Bar
Backrest
Bar [7]
REV 04j; 07d
Fig. B, Collapsing the Walker/Stroller
