Page 10
SKU 45703
Pelmeni Pasta Profiling
1.
Assembly the Pelmeni Pasta Accessory as illustrated below.
2.
Place the attachment on the Worm Drive and Mincer accessory, instead of cutter and
grille.
3.
Match the attachment slot with the Housing lug, and secure it with the Nut.
4.
Turn the machine on to the speed II or III.
5.
Knead the dough, then cut a small piece and feed it through the Housing funnel.
A strip of dough will come out of the attachment. If it is the correct length, continue. If it
is not, adjust the amount of dough used.
6.
Turn the machine off and tear the strip off and roll it, if necessary.
Note:
Avoid long pauses in this process to avoid having the dough dry out and clog the
attachment.
7.
When finished, unplug the machine from the electrical outlet.
Coffee Mill
1.
Attach the (preassembled) Coffee Mill accessory to the Motor Base by twisting it in
place.
Refer to the illustration at the top of page 11.
2.
Turn the Regulator dial to the desired grind (1-7).
3.
Fill the Load Cup with dry coffee beans.
4.
Place the Receiving Container in its holder.
