Page 3
For technical questions, please call 1-888-866-5797.
Item 56658
Set Up
Read the ENTIRE IMPORTANT SAFETY INFORMATION section at the beginning of this document
including all text under subheadings therein before set up or use of this product.
TO PREVENT SERIOUS INJURY FROM ACCIDENTAL OPERATION:
Switch the Remote Control OFF before performing any procedure in this section.
Charging Battery
CAUTION! Do not leave Drone unattended
while charging. Battery charging
should be done by adults only.
1. Make sure Drone and Remote Control are turned OFF.
2. Remove Battery from battery
compartment on back of Drone.
3. Plug Battery cable into the back of the USB Adapter.
USB
Adapter
Battery
4. Plug the USB Adapter into a USB power source.
5. While Battery is charging, LED light on USB
Adapter is on. When fully charged, LED light
turns off. Charging takes approximately 1 hour.
6. When charging is complete, disconnect battery
from USB Adapter and power source.
Remote Control
1. Remove the screw securing the Battery Cover
on the back of the Remote Control.
Battery
Cover
2. Remove the Battery Cover and insert three AAA
batteries (sold separately) in the indicated polarity.
3. Replace Battery Cover and tighten screw securely.
CAUTION!
Do not install old and new batteries
together. Do not install alkaline, carbon-
zinc or rechargeable batteries together.
Position batteries in proper polarity. Do
not use swollen or leaking batteries.
Specifications
Remote Control
Battery Type
3 – AAA (sold separately)
Drone Battery Type
3.7 V / 380 mAh rechargeable
Lithium-Polymer
Battery Charging Time
65 minutes
Flying Time
Approximately 6 minutes
Range
Up to 50 meters (about 150 feet)
Operating Frequency
2.4 GHz
