Page 8
For technical questions, please call 1-888-866-5797.
Item 56814
Operating Instructions
Read the ENTIRE IMPORTANT SAFETY INFORMATION section at the
beginning of this document including all text under subheadings therein
before set up or use of this product.
TO PREVENT SERIOUS INJURY: Operator and spectators must wear ANSI-approved
safety goggles during use. Keep Drone within 160 feet of Remote Control. If Drone
goes out of range, it will stop working and fall.
WARNING!
To prevent serious
injury, avoid sudden movements
of controls while flying.
CAUTION!
Only fly outdoors during
daylight hours in an area with no
obstructions, power lines, vehicles,
animals or people nearby.
Pairing
1.
Turn the Drone ON – the red and
green LED lights will flash. Place
the Drone on a flat surface.
2. Turn Remote Control ON. Unit
will beep once, the blue Power
Indicator Light will come on, and
the red Camera Light will flash.
3. Push Throttle all the way up, the unit
will beep once. Then push Throttle all
the way down until unit beeps again.
4. The red Camera Light on the Remote
will go out and the blue Power Indicator
Light will stay on, indicating the
Drone and Remote are connected.
Auto Trim Function
1. When pairing is complete, place
Drone on a flat surface.
Simultaneously pull the Throttle
stick and the Directional stick
down at a 45 degree angle as
shown until the Drone’s LED
lights flash.
2. Release the Throttle and
Directional sticks. The LED
lights stop flashing and remain
on when auto trim is complete.
Speed Control
Drone speed is set to slow by default.
To change to medium speed, press the Throttle
Joystick down once — the Remote will beep twice indicating speed is set. For high speed
press the Throttle Joystick down again — the Remote will beep three times indicating speed
is set. To return to slow speed press the Throttle Joystick once — the Remote will beep once
indicating speed is reset to slow.
