Page 10
For technical questions, please call 1-800-444-3353.
Item 60239
NOTICE
Clean the Spray Gun IMMEDIATELY after use.
Delayed or inadequate cleaning will permanently clog the Spray Gun.
SAFETY
Op
ERA
TION
M
AINTENANCE
SETU
p
Workpiece and Work Area Set Up
1. Designate a work area that is clean
and well-lit. The work area must not
allow access by children or pets to
prevent distraction and injury.
2. Route the air hose along a safe
path to reach the work area without
creating a tripping hazard or exposing
the air hose to possible damage.
The air hose must be long enough to reach
the work area with enough extra length
to allow free movement while working.
3. Before spraying, mask nearby
objects not being sprayed and lay
cloths (not included) on the floors.
Note:
Large Spray Gun pictured. The Detail
Spray Gun has the same components and
controls and is assembled, operated and
maintained the same way as the larger gun.
Nozzle
Trigger
Lock Ring
Fluid
Knob
Pattern Knob
Air Inlet
Air Knob
Cup
Figure C: Components and Controls
Spray Gun Setup Adjustment
TO pREVENT SERIOUS INJURY:
Do not adjust or tamper with any control or component in a way not specifically explained
within this manual. Improper adjustment can result in tool failure or other serious hazards.
CAUTION! Keep hands away from Trigger while making adjustments.
1. Thread the Cup to the top of the Gun Body
and tighten until the Cup is securely in place.
Note:
This Spray Gun is meant for spraying
oil-based paints. It is not recommended for
regular wall paint or thin coatings of any type.
While these products can be used with
this Spray Gun, coverage will not be even.
paint preparation and Filling
Note:
Proper paint mixture is essential.
Follow the manufacturer’s directions. Most paints
will spray easily if they are thinned properly.
2. Thin the paint according to manufacturer’s
directions and mix thoroughly.
3. Carefully strain the paint through
a paint strainer or a piece of cheesecloth.
4. Fill the Cup to 3/4 full. Close Cup.
5. Start the air compressor and set
the regulator to needed pressure.
Do not exceed maximum air pressure.
Summary of Contents for 60239
Page 1: ......