Page 2
For technical questions, please call 1-888-866-5797.
Item 62527
Specifications
Batteries Required
4x “AA” Batteries (for Car)
1x 9V Battery (for Remote)
Frequency
27/49 MHz (See Product Label)
This device complies with part 15 of the FCC Rules. Operation is subject to the following
two conditions: (1) This device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause undesired operation.
Important Safety Information
1.
Changes or modifications not expressly
approved by the party responsible
for compliance could void the user’s
authority to operate the equipment.
2.
Follow basic safety precautions to
reduce the risk of personal injury and/
or damage to the product during use.
3.
Do not allow children younger than age 6
to use this Stunt Car.
Children should
not operate without adult supervision.
4.
Do not swing Remote Antenna near
your face or near other people.
5.
Keep spectators and pets away.
Spectators
should only watch from a safe distance.
6.
Position batteries in proper polarity.
Do not install batteries of different types,
charge levels, or capacities together.
7.
Do not open the Stunt Car’s housing or
modify its design.
Doing so may cause
damage and/or make it dangerous.
8.
Do not use if parts are loose
or damaged.
If the toy has been
damaged, immediately stop using it.
9.
Only use outside or in large,
enclosed area.
Do not drive near open
flames, pets, or delicate furniture.
10.
If you lose control of the Stunt
Car, release the buttons.
11. The warnings, precautions, and instructions
discussed in this instruction manual cannot
cover all possible conditions and situations
that may occur. It must be understood by
the operator that common sense and caution
are factors which cannot be built into this
product, but must be supplied by the operator.
12. Maintain product labels and nameplates.
These carry important safety information.
If unreadable or missing, contact
Harbor Freight Tools for a replacement.
Assembly
1. Carefully slide the cardboard support
containing the Stunt Car out of the packaging.
2. Remove the Remote.
3. Remove the Stunt Car from the cardboard. If
any part does not slide out easily, stop and
clear the obstruction before proceeding.
Installing Batteries
Remote
1. Unscrew and remove the battery
cover on the back of the Remote.
2. Insert one 9-Volt battery (not included)
into battery compartment,
following indicated polarity.
3. Replace the Remote battery cover.