SKU 65003
For technical questions, please call 1-800-444-3353.
Page 9
SpECiFiCatiOnS
Electrical
Requirements
120 V~ / 60 Hz
Charging Time
3-5 Hours
Battery Pack
Voltage
DC 18V
Max. Air Speed
99 MPH
Battery Pack
Capacity
1300mAH
Battery Type
Ni-CD
Dimensions
39-1/4” L x 5-7/8” W x 9” H
unpaCKing
When unpacking, make sure that the
item is intact and undamaged. If any parts
are missing or broken, please call Harbor
Freight Tools at the number shown on the
cover of this manual as soon as possible.
inStRuCtiOnS FOR
putting intO uSE
Read the EntiRE impORtant
SaFEtY inFORmatiOn
section at the beginning of this
manual including all text under
subheadings therein before set
up or use of this product.
tO pREVEnt
SERiOuS injuRY
FROm aCCiDEntaL
OpERatiOn:
turn the power Switch of the
tool to its “OFF” position and
unplug the tool from its
electrical outlet before
assembling or making any
adjustments to the tool.
note:
For additional information regarding
the parts listed in the following pages,
refer to the Assembly Diagram near
the end of this manual.
installing/Removing Battery pack
Always make sure Blower is switched
1.
off before inserting or removing Bat-
tery Pack (12).
To remove Battery Pack, press the
2.
tabs on each side of the pack and
remove from Blower.
After Battery Pack is fully charged,
3.
align the Pack’s tongue with the
grooves in the housing. Slide Pack
into place until it “clicks” into place.
Charging Battery pack
Charge Battery Pack only with the
1.
18V charger provided. See
Figure a
,
below. Charge indoors only.
Insert Battery Pack into Charger
2.
Stand (24). Plug Charger (23) into
appropriate AC 120V, 60 Hz power
outlet. The red LED light on Charger
Stand will activate, indicating battery
is charging.
The initial charging time is 3-5 hours,
3.
after which the Battery Pack should
be removed. Once fully charged, the
green LED light will activate. Please
Blower
Charger (23)
Battery Pack (12)
Charger Stand (24)
Battery Pack (12)
