Harbor Freight Tools 66687, Set Up And Operating Instructions Manual

Page 7

For technical questions, please call 1-800-444-3353.

SKU 66687 

move though on screen menu and guide. 

With some DBS (direct broadcast satellite) 

models up and down. On some DBS 

models the INFO button should be used to 

select the highlighted item.

cHannel controls: 

Used for 

changing the channels.

volume:

 Increases or decreases the 

volume.

device controls

 (REVERSE, PLAY, 

FORWARD, REC, STOP, PAUSE)

:  

These 

buttons are for DVD//VCR/DVR use and 

operate the same as your original remote. 

You must press the RECORD button twice 

to start recording.

inFo: 

Shows the date and the time if your 

TV or VCR has that feature.

clear: 

Removes the on screen display 

to return to normal viewing. 

set up instructions

battery installation

Remove the battery compartment 

1. 

cover from the back of Remote.
Install (2) “AA” batteries, making 

2. 

sure to install according to indicated 

polarity.
Slide battery compartment battery 

3. 

over batteries and snap into place.

note:

 Reprogramming may be required 

after batteries have been replaced.

setting the code from  

the code lists

Find your device brand on pages 

1. 

11 through 18 and follow the steps 

below. 

note:

 Some brands have more than one 

code in the listings. You may need 

to repeat the following steps, trying 

several of the codes until you find the 

code that works with the Remote and 

your device. 
Turn on the device you want to 

2. 

program into the Remote.
Aim the Remote at the device and 

3. 

press and hold the Code Search 

Button until the LED Indicator Light 

turns on and stays solid red.  Release 

the button.
Press and release the Device Select 

4. 

Control button for the device that you 

are programming (CABLE, TV, VCR, 

DVD OR SAT). The LED will blink 

once, then remain solid.
Enter the corresponding 3-digit code 

5. 

using the number keys. The LED 

will blink as each number is pushed, 

then remain solid. You must enter the 

3-digit code within 30 seconds.   

If, after entering the code, the 

LED turns off, then the remote has 

recognized the entry. Go to the next 

step.  

If the LED flashes, the code is not 

recognized and you will need to 

repeat steps 3 - 5 for the next code 

in the list, or use one of the following 

alternate methods to find the code 

with the remote. 

note:

 The remote may recognize the code 

but the device may not. You may 

need to try more than one code to get 

the device to function.
When the LED has turned off, 

6. 

meaning the Remote has recognized