Page 4
For technical questions, please call 1-800-444-3353.
Item 67437
Assembly/Operation Instructions
Read the ENTIRE IMPORTANT SAFETY INFORMATION section at the beginning of this manual
including all text under subheadings therein before set up or use of this product.
Note:
For additional information regarding the parts listed in the following pages,
refer to Assembly Diagram near the end of manual.
Unfolding/Folding
1. Before unfolding Wheelchair, make sure
Rear Wheels (3) are in the locked position.
2. Hold the Armrests (10) and pull them away
from one another, unfolding the Wheelchair.
3. As Wheelchair unfolds, press down on Seat (6).
4. Swivel Footplates (2) so they are horizontal.
5. To fold the Wheelchair, lock the
Rear Wheels and fold Footplates up.
6. Pull up on the Seat and push Armrest
closer together, folding the Wheelchair.
Installing Foot Rests
1. Slide the Footplates (2) to the side so that they are
perpendicular to the Wheelchair. See Figure A.
2. Install the end of each Detachable Footrest (1)
onto the tab extending from
the Wheelchair Frame (9). See Figure A.
3. Swivel the Footrest towards the inside of
the Wheelchair until it locks into place.
Note:
When properly installed, Footplate will be on the
inside of the Wheel Chair when locked into place.
4. To remove, push the Control Handle out and lift
the Foot Rest off the Wheelchair. See Figure A.
Footplate (2)
Foot Rest (1)
Control
Handle
Tab
Figure A
Adjusting Foot Rests
1. To adjust the Foot Rests, loosen but don’t remove
the bolt that secures the lower section of each
Foot Rest to the upper half. See Figure B.
2. Reposition lower section of Foot Rest
to desired height. Tighten bolt until
upper section is secured at spot.
NOTE:
The Wheelchair may be used without Foot Rests
by persons able to use their feet to self-propel chair.
Figure B
Bolt
Upper
Foot Rest
Lower
Foot Rest
Summary of Contents for 67437
Page 1: ......
