Page 4
SKU 90750
Assembly
FIGURE 1
1. Thread the Body (1) to the Tripod (6) using the Body Connecting Screw (10).
See FIGURE 1.
Body Connecting Screw (10)
2. Attach the Spotting Scope Bracket (13) to the Body (1) with the two Chrome Nuts. Make
sure the longer end of the Spotting Scope (2) is pointed toward the front of the Telescope.
Refer to the Assembly Drawing on page 5.
3. Attach the Diagonal Eyepiece Holder (3) to the Focus Tube (11) by inserting and tightening
the Diagonal Screw (14) to securely hold it in place. Refer to the Assembly Drawing on page
5.
4. Place either one of the Eyepieces (7) (50X or 100X) into the Diagonal Eyepiece Holder (3),
and tighten the Eyepiece Screw (12).
Operation
1. Place the Telescope on a stable platform or on flat, level ground.
2. Remove the Objective Cover (9) and Spotting Scope Covers and set aside.
3. Turn the Angle/Bearing Adjusting Lever (5) counterclockwise to loosen it and allow the
Telescope to be angled to the desired location. Look through the Spotting Scope (2) to find
the general area you wish to view. Tighten the Angle/Bearing Adjusting Lever (5) when you
determine you are in the correct viewing area.
4. Look through the Eyepiece (7) and turn the Focus Knob (4) very slowly and gently to focus
in an object. Be very patient while attempting to focus in objects in the night sky.
Note: This Telescope will not view an object clearly unless it is a minimum of 150 feet away.
5. Replace the Objective Cover (9) and Spotting Scope Covers when finished.
WARNING! NEVER LOOK DIRECTLY INTO THE SUN WITH THE TELESCOPE.
LOOKING AT THE SUN CAN CAUSE PERMANENT EYE DAMAGE.
Body (1)
Tripod (6)
