SKU 91614
For technical questions, please call 1-800-444-3353.
Page
4
Warning:
The warnings, cautions, and instructions discussed in this instruction manual
cannot cover all possible conditions and situations that may occur. It must be
understood by the operator that common sense and caution are factors which
cannot be built into this product, but must be supplied by the operator.
Assembly and Operation
Your Two Burner Propane Stove will require some simple assembly as described in the following
steps. To assist you with assembly and operation please refer to the Operational Figures as well as
the Assembly Diagram and Parts List located on the last pages of this manual.
1.
Pull the Latches (6) up from the top and around to the bottom of the Stove-see Figure 1.
2.
Make certain that the stove is on a flat, level surface capable of supporting the weight of the
Stove and the items to be heated. Raise the Cover (1), then raise the Side Shields (2) on
both sides of the Stove. Insert the tabs on the Cover (1) through the hole in the side of the
Side Shields (2). Raise each Side Shield (2) completely into place so that the tab locks into
place at the end of the groove.
3.
Thread the Tube and Valve Adapter Assembly (4) onto the Stove-see Figure 2. Tighten
securely by hand or using a wrench.
4.
Make certain that both the Burner Control Knobs (8) are in the OFF position before attaching
the propane canister (not included).
5.
Attach the other end of the Tube and Valve Adapter (4) to the propane canister (not
included).
Burner Control Knob (8)
Figure 1
Latch (6)
Side Shield (2)
Burner and Fuel
Jet Assembly (7)
Tube and Valve Adapter (4)
Figure 2
Thread onto
Stove
Attach to propane
canister (not included)
Tube and Valve
Adapter (4)
