Page 4
SKU 94192
For technical questions, please call 1-800-444-3353
Optionally, if the Generator gas tank is empty, the Generator can be tipped on its back
frame for ease of mounting the Axle (49), Wheels (50), and Shock Absorbing Feet (54).
This should only be done on flat, cement surface.
2.
Open the bag of hardware and remove four Bolts (52), Nuts (57), Lock Washers (64),
Pins (51), Washers (63), and two Axle Brackets (53).
3.
Place Bolt (52) and Washer (63) up through Axle Bracket (53), then up and into the
Frame Cross Bracket. Secure from above with Nut (57), Washer (63), and Lock
Washer (64).
Repeat this step with each side of Axle Bracket (53), and the second Axle Bracket on
the other side. To not tighten Bolts completely at this time. (See photo below.)
4.
Slide Axle (49) through both Axle Brackets (53) and center Axle on the Generator
Frame.
5.
Using a wrench (not supplied), securely tighten all Bolts (52) holding the Brackets
(56).
6.
Insert Pin (51) into each end of the Axle (49). Bend Pin so it cannot fall out.
7.
Place each Wheel (50) over the end of the Axle and secure in place with another Pin
(51). Bend Pin so it cannot fall out.
Bolt (52)
Lock Washer (64)
Nut (57)
Pin (51)
Axle Bracket (53)
Axle (49)
Frame Cross Bracket
Air Valve (30 PSI)
Wheel (50)
Pin (51)
and Washer (63)
Washer (66)
