SKU 95082
For technical questions, please call 1-800-444-3353.
Page 10
allow access by children or pets to
prevent injury and distraction.
Route the power cord extension
2.
along a safe path to reach the Planer
without creating a tripping hazard or
exposing the power cord to possible
damage.
There must not be hazardous
3.
objects, such as utility lines or foreign
objects, that will present a hazard
while working.
general Operating instructions
Note:
Before operating, remove foam
backing material from the Table (95).
Measure the thickness of the wood
1.
stock to be planed.
Turn the Adjustment Knob (10) to set
2.
the thickness of the cut, using the
Scale (103) as a guide. See Figure
D, above. Each complete turn of the
Knob equals about 1/16 inch, up or
down. Set the thickness to 1/16 inch
less than the thickness of the wood
stock. Make thin cuts at first, then
increase the cut depth as required,
up to 3/32 inch (maximum).
Place the end of the wood stock in
3.
front of the Planer (wood grain facing
forward).
If the wood stock is long, support the
full length using a roller platform (not
supplied) or other device which is the
same height of the Planer Table (95).
5. Plug the Power Cord (157) into a 20
amp, 120V electrical outlet.
6. Lift the Switch Cover (162) and
push the Switch (161) to start. Allow
the planer to come up to full speed
before beginning a job.
7. When the motor is turning at full
Figure d
Crank
Handle (10)
Dust
Chute
(80)
Scale (103)
Table (95)
Switch Cover
(162)
Reset Button Circuit Breaker
(155)
Power Cord
(157)
