Page 16
For technical questions, please call 1-888-866-5797.
Item 57042
RETURNS NOT ACCEPTED & WARRANTY VOID
if Sprayer is not properly cleaned immediately after every use.
Clean Sprayer immediately to prevent permanent damage.
S
AFETY
O
PERA
TION
M
AINTENANCE
S
ETUP
User-Maintenance Instructions
After Every Use - Cleaning
WARNING! TO PREVENT SERIOUS INJURY: Only water-based materials or materials with a
minimum flash point of 38°C (100°F) should be used for spraying and cleaning.
Only use water
or mineral spirits for priming and cleaning. Only use water-based or oil-based paint for spraying.
1. Turn Power Switch off.
2. Depressurize Sprayer according to
Depressurize Sprayer on page 11.
3.
Lock Trigger.
4.
CAUTION! To prevent high pressure solvent
or paint splatter, remove Nozzle Guard,
Spray Tip, and Seal according to
Spray
Tip and Nozzle Guard on page 19
.
CAUTION! TO PREVENT INJURY: TO PREVENT
FIRE: When using mineral spirits, use metal
containers only. DO NOT use plastic containers.
5. Designate two 1 gallon containers, one
for solvent and one for waste.
6. Remove Suction and Priming Hoses from
paint container and wipe off excess paint.
7. Place Suction Hose on bottom of solvent container.
8. Place Priming Hose on bottom of waste container.
Suction
Hose
Priming
Hose
Solvent
Waste
9. Fill solvent container with enough
solvent to cover filter by 4".
• Water for water-based paint.
• Mineral spirits for oil-based paint.
10. Place Nozzle Guard, Spray Tip and
Seal in small container of:
• Soap and water for water-based paint.
• Mineral spirits for oil-based paint.
11.
Clean Pump
a. Turn Pressure Knob to
PRIME/CLEAN
indicator.
b. Rotate
PRIME/SPRAY
Valve to
PRIME
position.
c. Plug Sprayer into 120VAC grounded GFCI outlet.
d. Turn Power Switch on. Pump will
start. If pump does not start, turn
Pressure Knob clockwise until it starts.
e. When paint has been purged and solvent begins
to run clear, rotate
PRIME/SPRAY
Valve to
SPRAY
position. Pump will cycle on then stop.
12.
Clean Hoses and Spray Gun
a. Unlock Trigger.
b. Point Spray gun into paint container,
then press Trigger to pump excess
paint back into paint container.
c. Point Spray Gun at interior side
of waste container.
Note:
If using mineral spirits, hold Trigger Guard against
edge of metal waste container to ground Spray Gun.
Trigger
Guard
Waste
d. Press Trigger until solvent runs clear,
then release and lock Trigger.
13.
If mineral spirits used, clean again with water.
14.
When finished:
15. Rotate
PRIME/SPRAY
Valve to
PRIME
position.
a. Turn Power Switch off.
b. Unplug Sprayer.
c. Remove Hoses from containers.
d. Let Hoses dry completely before storage.
