Page 8
For technical questions, please call 1-888-866-5797.
Item 58608
SAFE
TY
OP
ERA
TI
O
N
M
A
INT
EN
A
NC
E
SE
TU
P
Operating Instructions
Read the ENTIRE IMPORTANT SAFETY INFORMATION section at the beginning of this
manual including all text under subheadings therein before set up or use of this product.
Work Area Set Up
1. Designate a work area that is clean and well lit.
The work area must not allow access by children
or pets to prevent distraction and injury.
2. There must not be objects, such as utility lines,
nearby that will present a hazard while working.
Setting and Testing
TO PREVENT SERIOUS INJURY FROM ACCIDENTAL OPERATION:
Make sure that the Trigger is locked and Battery Pack is removed
before performing any procedure in this section.
Loading the Grease Gun with a Grease Cartridge
1. Pull back on Follower Rod Handle until the
Follower Rod is fully extended. Pull Follower
Rod sideways to latch it into the slot on the End
Cap of the Grease Tube, locking it open.
2. Unscrew and remove Grease Tube
from Grease Gun Head Assembly.
3. Remove the cap from a grease cartridge (not
included), and insert the cartridge into Grease Tube.
4. Remove the pull tab from the grease
cartridge and screw the Grease Tube
back into the Head Assembly.
5. Open Air Bleed Valve.
6. Release Follower Rod from the slot on
the End Cap to allow the Follower Rod to
move forward into the Grease Tube.
Loading the Grease Gun from a Bulk Container
1. Unscrew and remove the Grease Tube
from the Grease Gun Head Assembly.
2. Insert the open end of Grease Tube into lubricant.
Slowly pull the Follower Rod back while pushing the
Grease Tube deeper into the lubricant to prevent air
pockets from being pulled into the Grease Tube.
3. When the Follower Rod is fully extended, pull
it sideways to latch the Rod into the slot on the
End Cap of the Grease Tube, locking it open.
4. Screw the Grease Tube into the Head Assembly.
5. Release the Follower Rod from the slot on the
End Cap of the Grease Tube to allow the Follower
Rod to move forward into the Grease Tube.
6. Clean any excess grease off the
outer body of the Grease Gun.
Loading the Grease Gun with a Filler Pump
1. Pull back on the Follower Rod Handle until
the Follower Rod is fully extended.
2. Remove plug on Bulk Loading Port.
3. Place bulk filler nipple (sold separately)
on the Port and insert into the socket
of filler pump (sold separately). Verify
socket is fastened securely to Valve.
4. Operate the filler pump until the
Grease Tube is filled.
5. Disconnect the bulk filler nipple from
the socket on the filler pump.
6. Move the Follower Rod forward
into the Grease Tube.
