Page 9
For technical questions, please call 1-888-866-5797.
Item 63536 63852
S
AFET
y
Op
ERA
TION
M
AINTENAN
c
E
S
ETU
p
General Operating Instructions
1. Make sure that the Trigger is in the off-position
and the Direction Switch is in the centered, Trigger
Lock position, then attach the Battery Pack.
2. Push and snap socket (not included) onto the Anvil.
3. Set Direction Switch.
Forward:
Push Switch in on right side
(arrow pointing forward) for clockwise rotation.
Reverse:
Push Switch in on left
side (arrow pointing backward) for
counter-clockwise rotation.
Trigger Lock:
Push Switch to the
center to lock the Trigger.
cAUTION! Set Direction Switch to center
Trigger Lock position during set up, when
changing sockets or when tool is idle.
push
for
Reverse
push
for
Forward
push Switch to center to
LOcK TRIGGER
NOTIcE: Do not change direction of rotation
while Anvil is rotating.
Wait until Anvil has come
to a complete stop before changing direction.
4. Position the socket over the fastener.
5. Press Trigger to start the tool. The Work
Light will turn on when Trigger is pressed
and turn off when Trigger is released.
6. The tool has variable speed. To increase
speed, apply more pressure to Trigger. To
decrease speed, lessen pressure on Trigger.
7. Tighten or loosen the fastener(s) as required.
Note:
The amount of actual torque will vary depending
on the cleanness and condition of the threads and
other factors. If tightening critical components,
chase threads before assembling components and
check the actual torque applied to the fastener
with a mechanical torque wrench (not supplied).
8. When finished using the Impact Wrench, release
Trigger and center Direction Switch to lock Trigger.
9. To prevent accidents, turn off the tool and
remove its Battery Pack after use. Clean, then
store the tool indoors out of children’s reach.
