Page 3
For technical questions, please call 1-888-866-5797.
Item 58203
Specific Safety Warnings
1. Do not exceed rated capacity.
2. Install on A-frame hitch before use.
3. Use on flat, level, hard surface
capable of supporting load.
4. Wear ANSI-approved safety goggles during use.
5. Prevent trailer wheels from moving using
wheel chocks while raising or lowering.
6. Before towing, fully raise Trailer Jack. Jack must
always be retracted when towing the trailer.
7. Keep out from under Jack and tongue when
applying and releasing load, when Jack is
supporting load, or when moving trailer.
8. Inspect before use. Do not use if
parts are loose or damaged.
9. Use in accord with DOT regulations.
10. Maintain labels and nameplates on
the tool. These carry important safety
information. If unreadable or missing, contact
Harbor Freight Tools for a replacement.
11. Apply force to Jack vertically only. Side
forces will compromise the Jack.
12. Do not use blocks for additional ground clearance.
13. Do not climb aboard any vehicle supported by Jack.
14. This product is not a toy. Keep it
out of reach of children.
15. Follow all state regulations for towing when
using Trailer Jack, including using safety
chains securely attached to the towing vehicle
when the trailer is hooked to the vehicle.
16. Check ground clearance carefully after
installing. If your trailer does not provide
enough ground clearance for the Jack, remove
the Jack entirely before towing trailer.
17. Do not use for aircraft purposes.
18. The warnings, precautions, and instructions
discussed in this instruction manual cannot
cover all possible conditions and situations
that may occur. It must be understood by the
operator that common sense and caution are
factors which cannot be built into this product,
but must be supplied by the operator.
SAVE THESE INSTRUCTIONS.
SAFETY
OPERA
TION
MAINTENANCE
INST
ALLA
TION
