1 2
Installation Instructions
Floor surface:
This appliance must be properly positioned on a dry, sturdy, level surface that is strong
enough to support it when it is fully loaded. Rotate left or right to adjust the levelling wheel if unstable.
If it is to be placed on carpet, support it with a wooden board underneath. This appliance is designed
to be freestanding only and should not be recessed or built in.
Clearances:
Ensure that air can circulate freely around the back of the cabinet, which is necessary to cool
the compressor and condenser. Allow at least 10cm clear space at the back and sides of the unit and 30cm
clear space above the unit. Failure to do so will increase compressor’s power and further increase power
consumption. It is also necessary to maintain distance for doors to open at least 90°.
DO NOT
install/use the appliance in the following locations/situations:
• In moist areas or areas of high humidity.
• In a recreational vehicle, or for use with an inverter.
• In direct sunlight, near heat sources, next to an open flame, cooking or heating appliance, or near
any other source of high heat.
• Direct sunlight may affect the acrylic coating and heat sources may increase the unit’s power
consumption. For best energy efficiency install the appliance in the coolest area of the room.
• In an area with extreme cold ambient temperatures.
• In an area with excessive moisture and high humidity. Make sure it is protected from elements such
as wind, rain, water spray or drips.
• In an area where petrol or other explosive and/or flammable liquids or fumes are used or stored.
The fumes can create a fire hazard or explosion.
