Hard Head 006046, Operating Instructions Manual

EN

12

2.  Turn the knob (main key) clockwise to 

open the door.

3.  Complete this operation, pull out the 

emergency key and store it in a safe place.

OPENING THE DOOR

1.  Enter the user code (3–8 digits). An audio 

prompt is given every time a button is 
pressed and the yellow light flashes.

2.  Press the button A ( C / #) or B ( E / *). 

The green light goes on.

3.  Turn the knob (main key) clockwise to pull 

the door within 5 seconds to open.

     FIG.   2

CLOSING THE DOOR

Turn the knob (main key) anticlockwise to lock 
the door.

AUTOMATIC LOCKING

If an incorrect code is entered three times in 
succession there will be an audio prompt for 
20 seconds.

SETTING THE USER CODE

1.  When the door is open, press the reset 

button. The new user code can be set 
when the yellow light goes on.

2.  Enter the new code (3–8 digits) and 

press the button A (C / #) or B ( E / *) to 
confirm. Two audio prompts are given 
to confirm that the new code has been 
stored.

3.  If the yellow light flashes and three audio 

prompts are given this means the code 
has not been changed. Repeat the above 
steps.

SETTING THE MASTER CODE

1.  When the door is open, press the 0 button 

twice and then the reset button. The new 
master code can be set when the yellow 
light goes on.

2.  Enter the new master code (3–8 digits) 

and press the button A (C / #) or B ( E 
/ *) to confirm. Two audio prompts are 
given and the yellow light flashes twice 
to confirm that the new master code has 
been stored.

3.  If the yellow light flashes three times this 

means the code has not been changed. 
Repeat the above steps.

EMERGENCY OPENING

The first time the safe is opened, during 
an electrical fault, or if you have forgotten 
the code, the safe can be opened with the 
emergency key.
1.  Remove the cover over the emergency lock.
2.  Insert the emergency key in the keyhole 

and turn it anticlockwise. Turn the knob 
(main key) clockwise to open the door.

     FIG.   3

     IMPORTANT:   

•  The default user code is 159. Enter the 

user code again if the yellow light 
flashes and three audio prompts are 
given.

•  The button pad is deactivated while the 

audio prompts are given. The audio 
prompts can only be stopped by using 
the emergency key and cutting the 
power supply be removing the battery.