ASSEMBLY INSTRUCTIONS
1. Remove all parts from packaging.
2. Place plastic brackets (11) on the inside of the desired crib corner post and press end of
brackets outward around the post.
3. Place a plastic connector (12) around the IV pole tube at the top just above the release
pin (7), and another at the bottom of the IV pole tube.
4. Holding the IV pole assembly with the release pin (7) facing outwards away from the crib,
turn the plastic connectors (12) to face the open ends of the plastic brackets (11), then
press plastic connectors into the plastic brackets until they lock together.
5. Align the holes in the bracket and connector, then tap in the two connector nuts (14)
into the holes in both the top and bottom brackets/connectors.
6. Insert the two screws (13) into the two connector nuts in the top bracket/connector
and begin to fasten but do not completely tighten them at this time. Repeat with the
bottom bracket and then go back and
fi
nish tightening the parts at the top.
*Do not overtighten the bracket/connector or the plastic may break prematurely as a
result.
7. Assembly is complete. Check the inside tube assembly to be sure it raises and lowers
freely when release pin (7) is pulled back and should lock in several positions when
released.
Plastic Bracket
IV Pole Assembly
Crib Post
Screws
Plastic Connector
21
