23
Incorrect assembly.
Pump valves blocked
or worn.
Defect pressure
gauge.
Filters clogging.
Nozzles worn.
Tank is airtight.
Sucking air towards
end of tank load.
Pressure filters
beginging to clog.
Agitation nozzles
clogged.
Air is being sucked
into system.
Excessive liquid
agitation.
Damaged diaphragm.
Fault
Probable cause
Control / remedy
Agitation nozzles not fitted.
Too little distance between yellow
suction pipe and tank bottom (only
800 l tank).
Check for obstructions and wear.
Check for dirt at inlet of gauge.
Clean all filters. Fill with cleaner
water.
If using powders, make sure
agitation is on.
Check flow rate and replace nozzles
if it exceeds 10%.
Check vent is clear.
Exessive agitation, turn off.
Returns inside tank need relocation.
Clean all filters.
Check by turning agitation off/on.
Check tightness / gaskets / O-rings
of all fittings on suction side.
Turn agitation off.
Reduce pump r/min.
Ensure returns inside tank are
present.
Use foam damping addative.
Replace. See Changing of valves
and diaghragms.
Lack of
pressure.
Pressure
dropping.
Pressure
increasing
Formation of
foam.
Liquid leaks
from bottom of
pump.
Summary of Contents for Boss Series
