6 - Maintenance
35
Anti-Yaw Damping
1.
Adjusting the damping on the Anti-Yaw is done by tightening or
loosening the tension on either side of the rubber dampers.
•
To make the damping tighter:
Loosen jamb nut (A), and tighten tensioner nut (B), making sure to
retighten jamb nut (A).
•
To make the damping looser:
Loosen jamb nut (A), and loosen tensioner nut (B), making sure to
retighten jamb nut (A).
ATTENTION! When loosening up the tension on the dampeners, there should always be a tension load on the
dampers. They should never be loose.
÷
NOTE. Factory adjustment is finger tight, then tighten the tensioning nuts another 10mm with a wrench.
Summary of Contents for Delta Force Boom
