EZ-Guide® Plus
Spiral
To use the adaptive curve pattern to get spiral guidance into the
center of the field:
1. From the Guidance menu, select Autodetect Turn to Off.
2. Start a new field using the Adaptive Curve pattern.
3. At the start of the headland, map Point A.
4. Drive around the headland.
5. When you are nearly back at Point A, map Point B.
6. Turn into the field. The next swath is generated off the last pass.
7. On each pass, when you are nearly back to where you started the
headland, reset B to mark the end of the swath.
Note
— Make sure that you are not within one swath width of the
start point. If you are, Point B will not be set.
Headlands
pattern
Use the Headlands pattern when:
• you need to apply the headland area first, to give you room to turn when you apply the straight swaths
• you want to know the area of the field You can do as many headland circuits as required before you change to straight
swaths. The headlands pattern automatically increments to the next headland when you enter the circle around the
start point of the headland.
Single
headland
1. Start the headland.
2. Drive around the field area. The headland is recorded.
3. Identify the current headland circuit as the final one.
The head- land is still recorded until you reach the circle around
the
start
point.
4. To map the start of the first straight swath, map Point A.
Note
— Do this before you enter the circle around the start point or
map A and B points.
5. Drive to the other end of the field and map Point B.
6. Enter the circle around the start point of the headland to complete the headland. The area is then displayed.
7. Turn left or right for the next swath. The next swath is automatically selected. Steer the vehicle to center the green
lights in the lightbar as you drive forward along the swath.
Note
— Straight swaths automatically fill the headland boundary. The AB Line does not need to be the full length of the
field.
15
Summary of Contents for EZ-Guide Plus
Page 30: ...EZ Guide Plus 30 ...