18
HARDI
®
FALCON BOOM OPERATOR‘S MANUAL
4. Suspend a 10 lb. (4.5 kg) weight from the cable at the straight edge-
to-cable contact point and check cable deflection by measuring the
distance from the straight edge to the cable. The cable should deflect
1/2” to 3/4”.
5. Loosen the lock nuts (
A
) (Fig. 5) on the turnbuckle assembly and adjust
the turnbuckle (
B
) (Fig. 5) for proper cable deflection.
6. Tighten the lock nuts (
A
)
( Fig. 5) and remove the weight.
IMPORTANT:
Check the boom alignment again. If the front cable
was tightened, the wing assembly will move forward; If loosened,
the wing will move rearward. Adjust the fold cylinder (if necessary)
as described in Alignment Of Wing Assemblies (Section 7.2).
7.4 Adjusting Wings Level To Ground
1. Ensure the wing is firmly supported.
2. Disconnect the rod eye (
B
) (Fig. 6).
3. Adjust the wing support to ensure the wing is level.
4. Loosen the lock nut (
A
) (Fig. 6) and adjust the rod eye (
B
) (Fig. 6)
to allow re-connection.
5. After connecting the rod eye (
B
) (Fig. 6), secure the lock nut (
A
)
(Fig 6).
Fig. 5
A
B
Summary of Contents for FALCON Boom Series
