25
HARDI
®
FALCON BOOM OPERATOR‘S MANUAL
8.4 In-Line Filters (Optional)
If in-line filters are fitted, they should be cleaned every 8hrs. (daily).
Unscrew the bowl to remove sediment.
8.5 Nozzle Tubes And Fittings
Poor seals are usually caused by:
• Missing O-rings or gaskets
• Damaged or incorrectly seated O-rings
• Dry or deformed O-rings or gaskets
• Foreign materials
Therefore, in case of leaks;
DO NOT
overtighten any fittings (Fig. 12).
Disassemble, check the condition and position of the O-ring or gasket,
clean, lubricate and then reassemble. For
radial
seals (O-ring) (Fig.12)
only hand tighten the fittings. Do not use pliers or wrenches.
The O-rings need to be lubricated
ALL THE WAY AROUND
before fitting
on to the nozzle tube.
HARDI
®
recommends using a veg-
etable based oil to prolong the life of
the O-ring.
100
Nozzle
Size
Nozzle
Screen
Green (20)
& Larger
80
50*
Red (16)
White (18)
Lilac (08)
Brown (10)
Yellow (12)
Orange (14)
*
Standard mesh
Inline Filters
(optional)
100
80
50*
Fig. 12
Summary of Contents for FALCON Boom Series
