1. Emergency
STOP of all functions
2. Status
diode
3. Main
ON/OFF
4. Spray pressure increase and decrease
5. AutoFill
start
6. AutoFill manual start and pause
7. AutoAgitation override control
8. Suction SmartValve override control
9. Pressure SmartValve override control
Basic to get going
Boom data, flow and speed calibration and volume rate
must be entered
Go to the menu on the Controller and find the relevant
section in the instruction book
Boom data
[3.1.1 Width]
[3.3.2 Number of sections]
[3.3.3 Nozzles pr. section]
Flow meter calibration
[3.2.1 FLOW CONSTANT]
The below PPU value is approximate and a practical
calibration is recommended
Volume rate
Press ¥ and hold until
[1.1 VOLUME RATE] is shown
SafeTrack
Hydraulic lever must be activated before the Controller is
turned on
Calibrate before use and when tractor is changed
Speed calibration
Press * and hold until one of the following is shown :
[3.1.1 Sprayer] Sensor on sprayer
[3.1.2 Tractor] Sensor on tractor
[3.1.3 Radar] Sensor is a radar
The practical calibration is recommended
ID Code
One outside groove
No outside groove
Orifice mm
13.5
20.0
Flow range L /min
5 to 150
10 to 300
Approx. PPU
120.00
60.00
1.
Status diode
2. Boom
sections
3. Main
ON/OFF
4. Tilt
5. Boom
height
6. Boom
slant
7. TWIN
presets
Grip HC 6300
FluidBox HC 6200
C
D
A
B
A SetBox 6400
B AUX Cable - 12 Volt (optional)
C Com 1
D Com 2
Grip HC 6300
The standard values for HARDI flow housing is :
