5 - Operation
57
Hydraulic slanting control
The hydraulic boom slanting control (6) enables slanting of the entire boom hydraulically. This is advantageous when
spraying across hillsides.
Reset position to neutral (midway) before folding the boom.
Slanting the boom (Y-models)
When driving on slopes, the boom can be slanted in order to match the
local topography.
At delivery the boom is locked in pos. 2 (neutral) which is used when
driving on horizontal grounds.
The slanting angle is adjusted as follows and with the boom unfolded:
1.
Remove the linch pin (A).
2.
Reset the position of the cylinder according to the holes (1, 2 or 3).
3.
Secure linch pin (A) again.
Minor adjustments of the boom in order to adjust it vertically can be
done by adjusting the position of nut (B).
Hydraulic Slanting Control (optional equipment):
The Hydraulic Slanting Control enables slanting of the entire boom
hydraulically. This is advantageous when spraying along hillsides.
μ
ATTENTION! Always reset position to neutral before foldingthe boom.
Half boom width
It is possible to spray with boom only half unfolded. In case this is needed then only unfold inner sections by pressing swich
(8) downwards. On the spray control unit also turn off the spray sections placed on outer boom sections.
2/3 boom width
Alternative boom widths can be obtained by folding outer section(s). The pendulum must always be locked if driving with
only one outer section folded in position.
±
WARNING! Use caution if driving with locked pendulum, and only do so on level ground. Reduce the period of driving
with locked pendulum to a minimum of time, as this setting reduces the life time of the boom.
Boom tilt function
The boom tilt function controls (3) and (5) enables you to adjust the boom height individually in right and left-hand side.
Night Spraying Light selector switch (optional)
The boom and work lights selector switch has three positions:
1.
Boom lights ON
2.
Lights OFF (neutral position)
3.
Work light ON
It is recommended to switch OFF the rear lights of the tractor in order to
reduce power consumption and avoid reflection.
μ
ATTENTION! If preferred the work lights can be controlled from
the tractor cabin. Connect from J4 in the work lights junction box
to the optional function on the spray control unit.
Summary of Contents for NAVIGATOR DELTA
