4 - Start up
23
7.
Place the input part towards the tractor. Fit the chains to prevent
the protection guards from rotating with the shaft.
μ
ATTENTION! To ensure long life of the driveshaft and prevent
possible damage to the equipment, try to avoid working at
angles of more than 15°.
Connecting the mistblower
The mistblower is designed for three point suspension and is factory
equipped with 22 mm pivots (category I).
Connect as follows:
1.
Connect the lower links ball ends of the tractor to the mistblower
lower link pins.
2.
Fit the linch pins to secure the lower links.
3.
Attach the top link to tractor and mistblower and adjust it by hand.
Secure with a linch pin.
4.
Lift the mistblower to working height.
5.
Ajdust the top link until the equipment is completely
perpendicular to the ground.
To detach the mistblower:
1.
Lower the tractor’s lower links with the hydraulic lever until the equipment is touching the ground.
2.
Loosen and remove the top link pin.
3.
Remove the top link.
4.
Lower the lower links and completely detach the mistblower.
5.
Drive the tractor away slowly.
±
WARNING! The tractor’s hydraulic lower links should be moved very gently to prevent damages or tipping over.
Summary of Contents for ZEBRA ATLAS
