Page | 33
When tensioning the blade, make sure the tracking adjustment bolt sitting behind the T handle
(pictured) is sitting back in its recess after you have finished and
before
the mill is run. Failure to do
this will result in the blade being thrown and possibly broken.
Tracking adjustment bolt sitting in
recess. It should look like this
before
the mill is started back up.
Tracking adjustment bolt out of
recess, of it looks like this DO NOT
start the mill until it is resting back in
its recess.
Ensure the blade support arm is locked
into place after tensioning the blade.
Summary of Contents for GT26
